Golf Ball Lever Release Clamp Maintenance
Golf Ball Lever Release Clamp Maintenance
If you're a golf pro, then you've no doubt heard of the handy ball head lever-release clamp.ball head lever-release clamp This nifty little device is the golf equivalent of the old "punch drill," and is used widely in today's golf world to release the golf ball with a single-handed touch. As one of the most important parts of the club, it should be well maintained and protected so that its usefulness can be fully utilized. Here are some maintenance tips for this versatile tool.
When cleaning the ball head lever-release clamp, first take the plastic cover off the ball. On some models, this is simply done by removing the cap on the ball. Next, clean the interior of the unit using a slightly moist towel. Use a soft, cloth-quality brush to remove any dust that might be stuck inside the assembly. Then, rinse the entire mechanism under warm tap water. Once thoroughly dry, replace the plastic cover back on the ball and test the mechanism to make sure it works as it should.
After cleaning and maintaining your golf ball head lever-release clamp, lubricate the moving parts with silicon-based products or quality oil. Also use lubrication if you anticipate that the screws will get worn out over time. The lubricant won't make a big difference in how long the mechanism lasts, but it's good to keep it lubricated in case it breaks as a result of excessive use. In addition, make sure the spring is tightly attached to the ball, especially when using a heavy club. A weak spring means that the ball will have a shorter distance to travel, so keep this in mind if you tend to let your clubs gather a lot of "marks."
You may also notice that your ball head has developed cracks as a result of frequent usage. If this is the case, simply reseal the ball clamp to remove any residual dirt or grease that's stuck to it. As a rule of thumb, you'll want to keep your ball lever-release clamp clean and dry, so wipe it down regularly and thoroughly. When it comes to your golfing clubs, it's always best to keep them well-maintained so that they last for years to come. Regular cleaning and maintenance will ensure that your clubs are working properly, so that you can get more out of every game!
To clean your golf ball lever-release clamp, first get all of the debris off of it. If there are pinholes or other foreign objects inside of the housing, these must be removed before you can get to it. Next, use a putter bar to dig out the old ball and clean it. You can either use a scrubbing compound, or a putter brush. You need to work fast, or the next thing you'll do could potentially cause permanent damage to the ball head. If the ball head gets dirty, it may be harder to clean, so you may want to leave it alone for now.
Once the old ball is clean and dry, you can fit the new ball head into the ball clamp and replace all of the screws. Make sure that the screws are tightened tightly and secure. Before you put the new ball in the ball head harness, make sure that it's installed firmly and securely. Tighten the screws just enough to hold the ball in place, but not so much that it causes any damage to your equipment.